D-MAX DMC-20SEC Manual de usuario Pagina 2

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 28
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 1
2
Macro Sensors Tel. (856) 662-8000
11 May, 2006 DMC-A2 Series (ALD-00029)
www.macrosensors.com
P
4 Secs
Input Setup
Start
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Prog.
SP1 SP2 SP4SP3 SP5 SP6
P
Prog.
SP1 SP2 SP4SP3 SP5 SP6
P
Calibration
Prog.
SP1 SP2 SP4SP3 SP5 SP6
P
P
Takes you into Input Setup mode and provides selection for:
• Supply frequency: 50 or 60 Hz.
• One of eight excitation settings for either 50 or 60 Hz.
• One of four output rates.
• Independent decimal point position for channels 1 and 2.
Takes you into Calibration mode and provides selection for:
• Either channel 1 or channel 2 for calibration.
2-point auto calibration for zero and span.
• Manual trim for zero offset.
• Manual trim for span.
See Page 3
See Page 4
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Prog.
SP1 SP2 SP4SP3 SP5 SP6
P
Analog Output Scaling
P
Takes you into Analog Output Scaling mode and provides:
A menu that allows you to set zero and full scale analog output calibration
settings.
See Page 5
P
Setpoints
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Prog.
SP1 SP2 SP4SP3 SP5 SP6
P
Takes you into Setpoint mode and provides:
• Selection of individual setpoints SP1 to SP4.
Setting of individual setpoint source.
Setting of individual setpoint activation value.
Setting of individual setpoint activation ABOVE or BELOW.
P
See Page 6
Allows you to change the displayed value:
Select either CH1, CH2, CH1+CH2 or CH1-CH2.
See Page 4
P
Select Display
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Table of Contents
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Intuitive Scrolling Text Menus . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
View Modes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Configuration Menus Logic Tree . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Input Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Calibration Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Calibration Mode Zero Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Analog Output Scaling Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Setpoints . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
Input Signal Setup Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Connector Pinouts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
Analog Output Scaling Example . . . . . . . . . . . . . . . . . . . . . . . . . . .12
Analog Output Signal Calibration Example . . . . . . . . . . . . . . . . . . .13
Application Examples . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14
Serial Communications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15
Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .26
Intuitive Scrolling Text Menus
Configuration Menus Logic Tree
After the controller has been powered up, the display settles
and indicates the input signal calibrated value. This is known as
the operational mode and is generally referred to as the
operational display throughout this document.
Intuitive scrolling text menus provide quick access to a range of
configuration modes for easy LVDT sensor application setup.
The Configuration Menus Logic Tree below describes the
configuration menus.
View Modes
The view modes allow easy viewing of the second channel
reading plus total 1 and total 2 if required.
P
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Operational Display
Example of
Channel 1
Reading
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Example
of Total 1
Reading
P
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Operational Display
Example of
Channel 2
Reading
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Prog.
SP1 SP2 SP4SP3 SP5 SP6
Example
of Total 2
Reading
Vista de pagina 1
1 2 3 4 5 6 7 ... 27 28

Comentarios a estos manuales

Sin comentarios