D-MAX DSC-300Si5 Manual de usuario descargar pdf (Pagina 24)

■ How to set TRACE

Move to [SET] after pressing „ F/N KEY ‟

F/F KEY Check – Control the scenes that you want to save a

joystick after the message “Set Trace: OO%” on the middle of

the screen.

If you are done with above action, move to [SAVE] with „ F/N

Key „

It goes to a higher menu after saving the data with the

message “Save TRACE”, if ‟ F/F KEY is pressed.

16. ALRAM CHANNEL ON/OFF

■ What is the ALARM function? : It uses a sensor and

operates to observe the location of the camera which

is memorized previously in the situation of the

warning signal or trespassers.

- CH On/Off: Alarm Input – Each channel can be ON/OFF

- Alarm Relay: It can be set „On‟ or „Off‟ when ALARM

OUTPUT PORT detects the alarm.

- Active Alarm: It can be selected to either ACTIVE OPEN or

ACTIVE CLOSE by the way of tangency.

ACTIVE OPEN: Alarm activates when Alarm input is set

“OPEN”

ACTIVE CLOSE: Alarm activates when alarm input is set

“CLOSE”.

- Resume Time Set:

When alarm activates during SWING, GROUP and TOUR,

camera moves to the place and this function allows you to set

dwell time(1~180sec) After designated time the camera goes

back to previous function(SWING, GROUP or TOUR).

If you stop the function while in use by joystick when Alarm is

not connected, Swing, Group or Group will be functioned after

the time you set.

Press SWING, GROUP or TOUR key if you want to put it to

stop completely. .

(Stopping the function by joystick will affect the SET function)

<< CAMERA SETUP p3 >>

16. ALARM CH ON/OFF PAGE

17. ALARM PRESET SET PAGE

18. Select Alarm : Sensor

19. Motion on/off : Off

20. Motion Detection Set :

21. PRIVACY ZONE SET :

- NEXT PAGE

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 44 45

Sin comentarios

D-MAX DSC-300Si5 Manual de usuario Pagina 24