D-MAX 33X Manual de usuario Pagina 30

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 38
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 29
30
Notes
When “AGC” is set to “OFF”, AUTO MODE cannot be used but, only use “COLOR
MODE” and “B/W MODE”.
When Use B/W mode under Sunlight or Halogen Lamp, the focus may be smear than
normal light.
DIS : The DIS mode can compensate for vibration of the camera.
Notes
When DIS is operating, D-ZOOM does not operate.
SYNC : Apply INIT mode.
INIT : Internal synchronization
COMM ADJ : Use this feature to select communication protocol. Position the indicator
over 'COMMUNICATION' by using the UP or DOWN button.
PROTOCOL : Select the communication PROTOCOL.
(D-max/STW/PELCO-D/PELCO-P)
CAM ID : Assign an ID number to the camera (1 to 255). Identification number zero is
used for Remote controller setup.
BAUD RATE : Configure baud rate from
2400/4800/9600/19200/38400/57600/115200
bps.
UART MODE : Configure parity bit to NON,
EVEN, or ODD. Data bit is set to 8bit, and stop
bit to 1bit. Set the UART MODE to EVEN if using
the Remote Controller.
TERMINATION : Function that sets the
resistance at the end of RS-485 communications.
PET PKT : Used to transfer a packet.
Notes
It can be setup any item in the COMMUNICATION SETUP by RS-485 interface except
for moving, exit of the menu. To be complete setup the items or parameter values, please
use key buttons on the rear panel of this camera or a remocon controller.
Vista de pagina 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37 38

Comentarios a estos manuales

Sin comentarios